Kneader Rubber Mixing Mill Conveyor Lifter Bucket Elevator For
Rubber
1. Usage:
This machine is mainly used in Rubber & Plastic Product factory for
Natural Rubber Mixing(plasticating),Raw Rubber and Compound
mixing,rubber warm-up mixing and pressing sheet.
Structure:
This machine consists of
Base,Rack,Gland,Rollers,Bearing,Transmission device,Lubrication
device,Decelerator,Adjustment device of the roller
temperature,Emergency shutdown device and brake rigging and etc.
1. The roller is made of chilled cast iron. It is divided into
hollowed roll and drilled roll. The inner of hollowed roll is
machined. The hollowed roll surface can be smooth or grooved. The
grooved roll has full grooved surface, partial grooved surface and
so on.
2. The roll is supported by roller bearing so it has low noise and
long service life.
3. The roll bearing adopts grease lubricating and oil lubricating.
4. The pressure transducer system is available for directly
displaying the working pressure and control the feed. When over
pressure, it will automatically stops and save or print the
pressure value.
5. The product is complied with nation-established safety standard
(this standard is identical with Europe standard.
2. Working Principle and Structural Feature:
This machine consists of Motor,Reducer, Machine Driven System of
china transmission,Guide Frame,Hopper,Electrial Control
parts,etc.The hopper move up and down on the guide frame and
turnover driven by the transmission system,two limits switch are on
the top and at starting position,to control the hopper.
3. Lubrication:
(1). Reducer,No.18 hypoid gear oil and almost.Firstly change oil
after two months,lator on change oil once each 6-12 months
(2). Filling lithium lubricating grease when overhaul each bearings
(3). Shelling-out the chains with No.30 machine oil once each
month.
4. Installation and Testing Run:
(1). The machine should be fixed as the foundation drawing and
filled foundation bolt;
(2). Check the degree of tightness of the chains and adjust them
appropriately.The Chains driving hopper should be tensioned
appropriately.
(3). During testing run,assure each parts to run stable,no JAM.If
not,adjust it timely.
5 Specification and Performance
| 1, Apply to type of Kneader | 35L/55L/75L/110L |
| 2, Lifting Speed of Hopper (m/min) | 9.5 |
| 3, Lifting Weight(kg) | 130 |
| 4, Speed of Mainshaft(r/min) | 25.9 |
| 5, Model of Chain | Chain 16A-1 |
| 6, Driving Motor Power(KW) | 1.5 |
| 7, Type of Motor | YEJ90L-4 |
6.Photos:
